Operating procedures for working with the MetroWerks' Hi-Wave C source level debugger:

1. Move the jumper on J5 from NCW position (No Code Warrior, left side) to CW position (Code Warrior, right side).
2. Move the jumper on J19 from NCW position (No Code Warrior, left side) to CW position (Code Warrior, right side).
3. Move the jumper on J15 to the middle position (BUFL).
4. Press the reset button on the FOX11 board to reset.
5. Change the Metrowerks IDE's baud rate from 19.2K to 38.4K. 
6. The Code Warrior IDE should talk to the FOX11 board.

The monitor for the Hi-Wave c source level debugger is programmed into U5, 27C256 EPROM and it's similar to 
the BUFFALO monitor, but it's a lot smaller.  
All jumper settings should be just like for the BUFFALO monitor, you only have to change jumpers on J5 and J19 to 
CW positions from NCW positions.

Don’t forget move the jumpers back to ‘NCW’ positions after exiting Code Warrior.